lu.ca/calc/

Lead and ball screws

Export

Margins

MS = allowable ÷ (FS × actual) − 1, one row per failure mode. Hover a row's icon to see the failure.

Speed against unsupported length

whirl and buckling limits · drag the point

Torque against load

drive and lowering torque at the screw · drag the line

Efficiency against lead angle

one curve per friction coefficient · left of the dashed line the thread holds by itself · drag the line

Motor

torque at the motor shaft, inertia and power for the fastest condition

Duty cycle

speed and load spectrum

Other sizes

same loads, speeds and supports · click a row to use it

Calculation

every step with this screw's numbers · the governing step is marked

Sources and assumptions