Friction coefficients
static μsliding μnut factor Kbars on a 0 – 1 scale · range where the source gives one
How to use these values
- Friction is a system property, not a material property: the same pair can differ by a factor of two with surface finish, contamination, load, speed and humidity. Use the range, and design to the end of it that is conservative for the check at hand.
- Joint slip (μT): use the lower value. Design codes give single values per surface class (EN 1090-2 classes A–D, RCSC/AISC Class A and B) that already include this.
- Thread and head friction (μG, μK) set the preload you get from a torque. A low friction value gives the highest preload (check bolt yield); a high value gives the lowest (check separation and slip). VDI 2230 friction classes A–E group typical surface and lubricant combinations.
- Nut factor K lumps thread and head friction into T = K·F·d. It is convenient for a first estimate; the μG/μK model in the bolt tools is more precise.
- Where sources disagree, each source has its own row. Rows from compilations are marked secondary. Standards behind a paywall are cited through the reproductions that were opened; the note says which.